 |
||
| AT2020-USB+ | ||
| Specification: | ||
| Type: | permanently polarized condenser | |
| Sample rate: | 44.1/48 kHz | |
| Bit rate: | 16 bit | |
| Capsules: | Cardioid | |
| Polar patterns: | ||
| Frequency response: | 20 - 20,000 Hz | |
| Sensitivity: | ||
| Max SPL: | ||
| USB Connection: | Yes | |
| XLR Connection: | No | |
| 3.5 Connection: | Headphone only | |
| Cable Length: | ||
| Power Requirements: | USB Power (5V DC) | |
| High-Pass Filter: | ||
| Software: | No | |
| Headphone amplifier: | ||
| Impedance: | ||
| Power output (RMS): | 130 mW (at 1 kHz, 10% T.H.D., 32 ohm load) | |
| Frequency response: | ||
| Signal-to-noise ratio: | ||
| Connector: | 3.5 mm TRS (stereo) | |
| Dimensions & Weight: | ||
| Dimension (LxWxH): | 162 x 52 mm | |
| Weight (grams): | 386 g | |
| Colourway: | ||
| Also compared to: |
